USD 64.78
Omron E3S-GS3E4 is an NPN grooved-type photoelectric sensor with 30 mm range, 12–24 VDC ±10%, 40 mA max., 1 ms max. response and IP67 protection.
The Omron E3S-GS3E4 is a grooved photoelectric sensor with NPN output and 30 mm sensing distance. It uses a 940 nm infrared LED, supports 12–24 VDC and has a 1 ms maximum response; the body is zinc die-cast with IP67 protection. The standard lineup specifies a 2 m cable and approximately 330 g packed weight; current supply status is recorded as Unknown.
A NPN grooved-type photoelectric with a rated sensing range of 30 mm.
| Parameter | Value |
|---|---|
| Sensing method | Grooved photoelectric detection |
| Sensing distance | 30 mm |
| Standard object | Opaque object, 6 mm diameter minimum |
| Minimum detectable object | 3 mm diameter black mark on transparent sheet |
| Light source | 940 nm infrared LED |
| Power supply | 12–24 VDC ±10%, 40 mA max. |
| Output | NPN; 80 mA max., 24 VDC max. load, 2 V max. residual; Light-ON/Dark-ON selector |
| Response time | 1 ms max. |
| Sensitivity adjustment | One-turn adjuster |
| Ambient temperature | Operating −25 to +55 °C; storage −40 to +70 °C; no icing or condensation |
| Ambient humidity | Operating 35–85% RH; storage 35–95% RH; no condensation |
| Enclosure rating | IP67 |
| Housing material | Zinc die-cast; polycarbonate lens and indicator window |
| Connection | 2 m pre-wired cable |
| Physical Weight (kg) | Approx. 0.330 kg packed |
| Dimensions L x W x H (cm) | See Omron dimension drawing; dimensions not transcribed numerically |
| Supply status | Unknown; current manufacturer supply state not established |
Engineering suggestions require suitability checks for your installation.
A narrow feed path may need to detect a small mark or passing opaque part without aligning separate emitter and receiver axes.
Position the grooved sensor around the material path and verify the 3 mm reference mark and mechanical clearance using the actual substrate.
A station may need a switching signal as a small object passes through a fixed slot.
Use the NPN output with a compatible controller input; validate the target and switching margin before production.
