USD 14.71
Omron TL-Q5MC1-F-Z 2M rectangular inductive sensor with 5 mm sensing, NPN normally open output and a 2 m cable.
The Omron TL-Q5MC1-F-Z 2M is a rectangular inductive proximity sensor in the TL-Q 5 mm sensing family. The family configuration uses a DC three-wire NPN open-collector normally open output, with a 12 to 24 VDC rated supply and 2 m cable. OMRON's family specification lists a 50 mA maximum output load, IP67 protection and a -25 to 70 °C operating range; supply status for this exact suffix is not confirmed.
5 mm rectangular inductive sensor with NPN normally open output and 2 m lead.
| Parameter | Value |
|---|---|
| Sensing principle | Inductive proximity sensing |
| Sensor format | Unshielded rectangular body; 17 × 17 mm face |
| Sensing distance | 5 mm ±10% |
| Set distance | 0 to 4 mm |
| Detectable object | Ferrous metal |
| Standard sensing object | Iron, 15 × 15 × 1 mm |
| Response frequency | 500 Hz |
| Output | DC 3-wire NPN open collector; 50 mA max. at 30 VDC max.; normally open |
| Power supply | DC 3-wire NPN open collector; 50 mA max. at 30 VDC max.; normally open |
| Current consumption | 10 mA max. at 24 VDC |
| Residual voltage | 1 V max. at 50 mA load and 2 m cable |
| Connection method | Pre-wired 2 m cable |
| Operating temperature | −25 to 70 °C; no icing or condensation |
| Storage temperature | −25 to 70 °C; no icing or condensation |
| Relative humidity | 35% to 95%, non-condensing |
| IP rating | IP67 (IEC 60529) |
| Housing material | Heat-resistant ABS |
| Physical Weight (kg) | Approx. 0.090 kg, packed state |
| Dimensions L x W x H (cm) | 17 × 17 mm sensing face; overall depth and mounting dimensions are shown in Omron's dimensional drawing |
Engineering suggestions require suitability checks for your installation.
A machine may need a discrete signal when a steel target reaches a defined position.
The NPN normally open output can switch a compatible control input as a suitable ferrous target approaches within the set distance.
An assembly station may need to sense a metal component without physical contact.
Mount the rectangular sensor near the target, then validate the gap, target dimensions and PLC input load against the OMRON specifications.
