Omron E2K-C25MF1 2M: c capacitive sensor, 25 mm (adjustable 3 to 25 mm) sensing, PNP DC three-wire output, long-distance mode, 2 m cable.
The Omron E2K-C25MF1 2M is an E2K-C long-distance capacitive proximity sensor with a 25 mm rated sensing distance, adjustable from 3 to 25 mm. This model uses PNP DC three-wire in NO operation with a 2 m pre-wired cable. Omron specifies 10 to 30 VDC operating range, IP66 protection and detection of conductors and dielectrics. Confirm target material and sensitivity adjustment in the installed application.
Omron E2K C capacitive sensor with 25 mm (adjustable 3 to 25 mm) sensing and PNP DC three-wire long-distance output.
| Parameter | Value |
|---|---|
| Manufacturer | Omron |
| Series | E2K-C |
| Product type | long-distance capacitive proximity sensor |
| Sensing method | Capacitive |
| Sensing distance | 25 mm (adjustable 3 to 25 mm) |
| Output | PNP DC three-wire |
| Operation mode | long-distance |
| Connection | 2 m pre-wired cable |
| Rated supply voltage | 10 to 30 VDC operating range |
| Degree of protection | IP66 |
| Sensing range adjustment | 3 to 25 mm |
| Response frequency | 70 Hz (E/F); 10 Hz (Y) |
| Cable length | 2 m |
| Operating temperature | -25 to 70°C |
| Ambient humidity | 35 to 95% RH |
| Packed weight | Approx. 200 g |
| Housing material | Heat-resistant ABS |
| Maximum load current | 200 mA (DC E/F); 5 to 200 mA resistive (AC Y) |
| Physical Weight (kg) | Not stated in the checked manufacturer product data. |
| Dimensions L x W x H (cm) | See manufacturer dimensional data; no complete overall L × W × H value stated. |
| Supply status | Unknown; exact specifications are confirmed, current supply status was not established. |
Engineering suggestions require suitability checks for your installation.
Detect a target at a machine station before an automated operation.
Set the sensor within the specified 25 mm (adjustable 3 to 25 mm) sensing range and connect its PNP DC three-wire long-distance output to a compatible controller.
Provide a non-contact signal for material or process presence.
Confirm the material, mounting conditions and sensing response in the installed application.
