1. Position Feedback for an Automated Transfer Sequence
A handling machine needs an electrical position event before advancing to the next transfer step. Mounted on a compatible actuator, the magneto-inductive sensor supplies a PNP normally open signal to the control input when the sensing condition is reached. Its 0.3 m M8 connection and clamped mounting provide a defined wiring and installation arrangement near the actuator.
Problem Solved
An actuator-position event becomes an electrical sequence input, allowing the controller to base the next process step on detected position rather than an elapsed-time assumption alone.
Magneto-inductive
PNP NO
0.3 m M8
2. Actuator Travel-Time Trend Monitoring
A maintenance system compares actuator-position event times over repeated machine cycles to identify a change in movement timing. The sensor's 0.5 ms switch-on and switch-off specifications provide a documented response characteristic for those events. A controller records the signals against its sequence timestamps; the sensor supplies position information rather than calculating travel time or diagnosing the cause itself.
Problem Solved
Consistent electrical position events give the control system inputs for travel-time comparisons, supporting investigation of changing actuator behaviour without requiring continuous manual observation of each cycle.
0.5 ms on
0.5 ms off
PNP events
3. Local Sensor-Position Adjustment During Commissioning
A technician sets the switching location on a compatible actuator while commissioning a fixture. Clamped mounting allows the sensor to be positioned at the required sensing point, and the yellow LED shows the switching condition locally. The specified 1.2 Nm tightening torque defines the mounting requirement, while the rotatable M8 screw lock supports connecting the cable in the installation.
Problem Solved
Local switching indication makes the sensing condition visible while the sensor is positioned, helping the technician establish the intended event location before relying on remote control feedback.
Yellow LED
Clamped mounting
1.2 Nm