1. Air-Signal-Controlled Transfer Cylinder
A machine uses pneumatic control signals to command a suitable double-acting transfer cylinder. The VSPA provides two directional working states and an exhausted-centre state, with mechanical spring reset and 3–10 bar control pressure at ports 12 and 14. Its 1000 l/min interlinked nominal flow and ISO 15407-1 interface characterize the valve within the cylinder's pneumatic control assembly.
Problem Solved
Pneumatic control signals select the cylinder circuit's directional routes, while the exhausted centre supplies a distinct vented valve state between the working commands.
Pneumatic actuation
5/3 exhausted centre
3–10 bar pilot
2. Vacuum-Compatible Routing with Positive Control Signals
A pneumatic handling circuit needs directional routing below atmospheric working pressure while retaining positive-pressure valve commands. The VSPA permits working pressure down to −0.9 bar and reversible flow, with 3–10 bar pilot signals supplied separately to the control ports. Its exhausted-centre function provides an additional vented routing state for the chosen working circuit, rather than a closed neutral path.
Problem Solved
The distinct working and control pressure ranges permit pneumatic actuation of a negative-pressure routing circuit, keeping the positive control signal independent of the working vacuum condition.
−0.9 bar working range
Positive pneumatic signals
Reversible flow
3. Pneumatic Motor Forward/Reverse/Neutral Commands
A machine uses a suitable reversible pneumatic motor and needs air-signal selection of forward, reverse and vented neutral routes. The 5/3 exhausted-centre valve supplies those circuit states through its ISO sub-base connections, with mechanical spring reset to centre. Its 13 ms on and 32 ms off component times characterize valve response, while motor run-down and mechanical stopping remain properties of the complete drive and load.
Problem Solved
One air-actuated directional valve provides forward, reverse and vented neutral routing, allowing the pneumatic command sequence to select motor supply paths without assigning unsupported stopping behavior.
Air-signal commands
13 ms on / 32 ms off
ISO sub-base