1. Direction Control for a Double-Acting Transfer Cylinder
A transfer fixture needs to drive a double-acting cylinder in either direction and select a closed centre routing state between commands. The 5/3-way valve provides that three-position arrangement with mechanical spring reset. Its 320 l/min nominal flow and separate 3–8 bar pilot requirement define the component conditions; leakage, cylinder load and the complete circuit still determine actual position retention.
Problem Solved
Three-position routing closes the working paths in the centre state, giving the circuit a defined intermediate valve condition between its two directional commands without promising leak-free load holding.
5/3 closed centre
Mechanical spring reset
320 l/min nominal
2. Vacuum-Circuit Path Switching
A handling circuit needs a directional valve whose working paths can operate below atmospheric pressure. This model is explicitly suitable for vacuum and permits working pressure down to −0.9 bar with reversible flow. A separate 3–8 bar pilot requirement supplies the actuation condition while the working circuit follows the selected vacuum and venting connections.
Problem Solved
Documented vacuum suitability permits switching of sub-atmospheric working paths, while the separate pilot-pressure range defines the positive-pressure actuation needed for that vacuum circuit arrangement.
Vacuum suitability
−0.9 bar
3–8 bar pilot
3. Valve-Station Commissioning
During assembly of a pneumatic valve station, technicians need to exercise routing states and correlate electrical commands with the installed valve. The detenting and non-detenting manual override provides local actuation, while signal indication makes the commanded condition visible. The 10 mm valve uses through-hole mounting with a specified 0.25 Nm maximum valve-mounting torque for installation.
Problem Solved
Manual actuation and visible signal indication support local routing checks during commissioning, helping technicians relate the electrical command to the selected pneumatic path at the valve station.
Manual override
Signal indication
10 mm