1. Tracking relative travel from a transport roller
A transport machine can couple the solid shaft to a suitable roller or drive shaft and count the A/B signals in external position electronics. The 8,192 pulses per revolution provide the rotational increment basis, with travel derived from roller circumference and gearing. Installed coupling and slip affect the resulting travel reference, while the controller uses compatible HTL/push-pull inputs.
Problem Solved
Incremental shaft counts give external position electronics a relative transport-travel reference, helping coordinate material movement against the measured rotation of the coupled mechanism.
Relative travel
8,192 pulses
HTL signals
2. Deriving shaft speed for drive monitoring
A compatible counter or drive can measure incremental pulse rate and calculate shaft speed. The six-channel HTL/push-pull interface connects rotation to the external electronics through a radial M12 connector. Integration assesses both the 600 kHz electrical output limit and mechanical speed restrictions, including speed-dependent self-heating at the selected ambient temperature.
Problem Solved
Pulse-rate feedback provides external drive monitoring with a measured rotation-rate reference, helping compare actual shaft motion with the commanded operating speed during machine operation.
Speed monitoring
600 kHz limit
Radial M12
3. Referencing a repeated rotary machine cycle
A cyclic machine can use the Z signal to identify one reference position per revolution after establishing its machine reference. The 90° electrical reference is logically gated with A and B, allowing compatible counting electronics to associate it with the incremental sequence. The encoder supplies relative rotational information rather than a retained multi-turn absolute position.
Problem Solved
A reference event within each revolution gives external cycle logic an index for aligning repeated motion and associating incremental counts with the established machine reference.
Rotary index
Reference Z
Cycle alignment