1. Confirming a metal clamp at its seated position
An assembly fixture can place a metal clamp target close to the quasi-flush sensing face at its intended seated position. The normally-open NPN output provides a reference to external sequence logic. Setup establishes the target gap using the 4 mm nominal and 3.24 mm assured ranges, actual material and geometry, and the specified quasi-flush installation clearances.
Problem Solved
A discrete seated-target reference gives external sequence logic a clamp-position condition, helping coordinate a dependent assembly operation when the expected metal target reaches the sensor.
Clamp position
Quasi-flush M8
NPN output
2. Counting metal tabs on a repeating mechanism
A repeating mechanism can move separated metal tabs past the M8 sensing face and deliver NPN transitions to external counting electronics. The 500 Hz rating provides a basis for assessing tab-passage frequency and spacing. Installation maintains the commissioned gap and the documented quasi-flush clearances while accounting for target material and shape along the motion path.
Problem Solved
Repeated metal-target transitions give external counting electronics cycle or passage events, helping track mechanism movement through a compact stationary sensing point beside the tabs.
Metal-tab count
500 Hz
External counter
3. Monitoring metal stock at a feeder reference
A feeder can position the sensor beside a reference location normally occupied by metal stock. The normally-open output changes when material leaves that region, and external monitoring times the absence against the expected feed sequence. The commissioned gap reflects the actual stock material and section, using the assured range and approximate reduction factors as setup references.
Problem Solved
A sustained target-absence condition supplies external feed monitoring with a stock-continuity reference, helping identify missing metal at the selected location before the next process step.
Stock continuity
External timing
Metal sensing