1. Confirming a cylinder at its transfer position
A transfer cylinder can use the C-slot sensor at a selected stroke position so that the piston magnet operates the normally-open reed signal. External sequencing logic reads that condition before requesting the next handling step. Setup adjusts and fixes the sensor position while checking the actual cylinder magnet, typical overrun distance and load against the electrical switching limits.
Problem Solved
A piston-position reference helps external transfer logic recognize the selected cylinder position and coordinate the following handling operation without measuring the full stroke continuously.
Cylinder sequence
C-slot mounting
Reed signal
2. Timing cylinder arrival after an actuation command
A pneumatic station can start an external timer when it commands a cylinder movement and stop that timer when the reed sensor reports arrival at the selected position. The C-slot mounting and normally-open signal establish the arrival reference. Commissioning checks actual piston-magnet behavior, travel direction and the 500 Hz specification against the station timing requirements.
Problem Solved
An arrival event gives external timing logic a repeatable endpoint for comparing command-to-arrival duration, helping identify a cylinder movement that takes longer than the configured process window.
Arrival timing
External timer
Position event
3. Counting repeated cylinder cycles for maintenance records
A machine can count transitions at a selected cylinder position in an external maintenance counter. The reed sensor supplies a normally-open event as the piston magnet passes its installed C-slot location. The counter validates the expected sequence to avoid counting repeated transitions as separate cycles, and setup respects the sensor switching frequency, current and power limits.
Problem Solved
Position events let external maintenance logic accumulate cylinder-cycle records, providing a usage reference for planned service while leaving counting and record storage in the controller.
Cycle counter
Maintenance record
External evaluation