1. Confirming a metal carrier at a transfer stop
A transfer station can present a qualified metal carrier feature to the sensing face at its defined stopping position. The 4 mm nominal range and 3.24 mm assured range guide placement for non-flush mounting. A compatible AC load circuit evaluates the NO switching condition and supplies the external sequence controller with a local position reference.
Problem Solved
A noncontact carrier-position condition gives the external transfer sequence a local arrival reference without placing a mechanical sensing lever in repeated contact with the monitored metal carrier.
Carrier position
4 mm range
AC NO
2. Checking a metal component in an assembly fixture
An assembly fixture can bring a qualified metal component into the detection zone at a defined inspection point. The AC two-wire switching condition reports local presence to compatible external control equipment. Material reduction factors guide qualification of stainless steel, aluminum and copper parts, and the control circuit interprets the selected output condition before advancing the assembly sequence.
Problem Solved
A metal-presence condition helps the external control sequence identify an empty monitored fixture position without relying on a visible surface mark or a contact probe against the component.
Fixture presence
Metal targets
Material factors
3. Counting spaced metal carriers on a conveyor
Separated metal carrier features can pass through the detection zone and deliver switching transitions to compatible external counting equipment through the AC load circuit. Target spacing and event rate must remain within the 25 Hz switching frequency. Circuit design must also meet the minimum 8 mA load requirement and the documented off-state-current limits.
Problem Solved
A qualified carrier-passage event supports throughput tracking without a contact counting arm, while external equipment performs the count and coordinates the material feed at the monitored conveyor location.
Carrier counting
25 Hz
External counter