1. Checking a metal insert in a small assembly fixture
A compact assembly fixture can position a qualified metal insert near the sensing face at a defined inspection point. The 1.5 mm nominal and1.215 mm assured ranges guide placement, with the documented reduction factors considered for different target metals. The normally-closed PNP output turns off when the target is detected, giving the controller a local presence condition.
Problem Solved
A noncontact insert-presence input allows the assembly sequence to flag an empty monitored position before the next operation, without requiring a mechanical probe against the small component.
Insert presence
Miniature housing
PNP NC
2. Counting small metal parts at a guided feeder
A guided feeder can present separated qualified metal parts across the sensor detection zone. An external counter reads the selected transition of the PNP normally-closed output as each part approaches or leaves. The 600 Hz switching frequency, specified hysteresis and material reduction factors guide target qualification and spacing at the feeder exit.
Problem Solved
A part-passage signal supports quantity tracking without a counting lever touching the components, while the external controller performs counting and coordinates the subsequent feed sequence.
Metal-part counting
600 Hz
External counter
3. Referencing a metal flag on a small mechanism
A small mechanism can move a qualified metal flag past the sensing face at its designated reference position. Flush installation and the8 mm body width support placement within a compact fixture. The external controller reads the normally-closed output transition, while the1.215 mm assured range and required mounting clearances determine the qualified flag position.
Problem Solved
A discrete flag-reference input helps the controller coordinate a repeat mechanism cycle without a contact cam switch, leaving position sequencing and machine actions to the external control program.
Flag reference
Flush installation
Compact fixture