1. Three-State Linear Transfer Control
A pneumatic transfer axis needs extension, retraction and a neutral valve command between machine steps. The 5/3-way closed-centre function supplies the two directional working states and a centre state that blocks the valve working paths. The ISO 5599-1 size 1 sub-base and 1300 l/min interlinked nominal flow characterize the selected valve station, with internal piloting within a 3–10 bar operating range.
Problem Solved
The closed centre provides a distinct blocked valve-routing state between directional commands, giving the controller a neutral circuit command alongside extension and retraction.
5/3 closed centre
ISO 5599-1 size 1
1300 l/min
2. Gripper Circuit with a Closed Neutral State
A handling machine needs open, close and closed-neutral valve commands for a suitable double-acting pneumatic gripper circuit. The closed-centre function supplies the third routing state, while internal piloting operates within the 3–10 bar working range. A three-pin M12x1 central plug supplies the electrical commands, and 1.6 W characteristic coil power defines the electrical load for the selected 24 V DC command interface.
Problem Solved
Three directional routing states support the gripper sequence, while the central electrical connection and specified coil power define the valve interface for the controller command circuit.
Closed neutral
Internal pilot
24 V DC / 1.6 W
3. Reversible Pneumatic Motor Routing
A machine uses a suitable reversible pneumatic motor and needs forward, reverse and closed-centre neutral routing commands. This valve supplies those states through its ISO 5599-1 size 1 interface, with a three-pin M12x1 central electrical plug. Specified 22 ms on and 65 ms off times characterize the valve component, while motor run-down and stopping behavior remain properties of the complete drive and load.
Problem Solved
One electrically commanded valve provides forward, reverse and closed-centre neutral air routing, with documented component switching times for evaluating its place in the pneumatic motor command sequence.
Forward/reverse/closed neutral
22 ms on
65 ms off